Area/Volume Keys
[Length]
Enters the value for Length in dimen-
sion problems (e.g., for calculating area
or volume).
Note: This key is also used to
enter the length for “Square-ups” and the
“Run” for stair problems.
[Width]
Enters the value for Width in dimension
problems (e.g., calculating area or vol-
ume).
Note: This key is also used to enter
the width for “Square-ups.”
[Height]
Enters the value for Height in dimen-
sion problems (e.g., for calculating vol-
ume).
Note: This key is also used to enter
the “Rise” for stair problems.
[Vol]
Volume — Computes the volume
(Length x Width x Height) in Cubic
Yards based on entered Length, Width
and Height values. A second press will
display the area (in square feet) based
on entered Length and Width. Successive
presses will toggle the display between
the calculated area and volume.
[Conv] [Vol]
Area — Computes the area in Square
Feet based on entered Length and Width.
User’s Guide – 9
To Next Page
Loading...
