[mm]
Millimeters — This is an entry and con-
version key used to enter or to convert
to decimal millimeters (when used in
conjunction with the [Conv] key).
[Weight]
This key is used to convert a dimen-
sioned cubic value or volume, to a
weight value using the [Conv] key and
the stored Weight per Volume (see
below). For example, 5 [Cu] [Yds]
[Conv] [Weight] equals 7.5 tons, or 10
[Weight] (tons) [Conv] [Cu] [Yds] equals
6.666667 cubic yards. Repeated press-
es of this key, after a cubic entry or
conversion, will toggle between tons,
pounds and kilograms.
[Conv] [%]
Weight per Volume — Used to set the
Weight per Volume. Can be programmed
as Tons per Cubic Yard, Pounds per
Cubic Yard, or Kilograms per Cubic Meter.
Default is 1.5 Tons/Cu. Yd. To set a dif-
ferent weight per volume, for example, 2
Tons/Cu. Yd, press 2 [Conv] [%]. Value
will be permanently stored. To recall
stored value, press [Rcl] [%].
8 – ConcreteCalc™
To Next Page
Loading...
