34 — DigiRoller
™
Plus II
Using AutoCount/Fixed Distance Mode
The DigiRoller
™
Plus II has an AutoCount mode that allows you to
count how many times you’ve rolled a programmed distance (that
you’ve set). If the bell is on, you will hear a short beep each time you
roll that distance and the counter in the upper left of the display will
increase by one.
For example, you want to count the number of times that you roll
6 feet 8 inches.
Step: Key:
Enter AutoCount Mode [Set] [AutoCount]
(
Feet-Inch
starts flashing)
The Feet-Inch annunciator will start flashing. Press [M+] if you
want to change the units of measurement.The display will
scroll through the various units of measurement. Press [Set] to
select the measurement unit and begin storing.The first zero
(0) will start flashing.
Accept Feet-Inch as Units [Set]
Enter 6 feet [M+]
(
0
starts flashing) (press six times)
Store feet measurement [Set]
(
-00
starts flashing)
To Next Page
Loading...
Need help?
General
