User’s Guide — 29
Editing Stored Measurements
Duplicating values in an Area Number register:
Step Key
Find Area Number Register with the value [Area#]
you want to duplicate
Find the value you want to duplicate [L]
OR [W]
OR [H]
Store measurement in permanent memory [M+]
Find Area Number with the value [Area#]
you want to replace
Recall replacement value [Rcl] [M+]
Replace old value with duplicated value [Set] [L]
OR [Set] [W]
To replace a value in an Area Number register:
Step Key
Roll measurement [Start/Stop]
Store measurement in permanent memory [M+]
Find Area Number Register with the value [Area#]
you want to replace
To Next Page
Loading...
Need help?
General
