Calculated Industries DigiRoller Plus II - Getting Started with Your DigiRoller Plus II; Turning the Unit On and Off; Setting the Device to Metric Mode

User’s Guide — 3
GETTING STARTED
Turning the DigiRoller
™
Plus II On/Off
On/Off Key
Turn the DigiRoller
™
Plus II on by pressing the [On/Off] key. To turn
it off, press the key again.
Auto Shut-Off
The DigiRoller
™
Plus II is designed to shut itself off if not used for 4-6
minutes. Values shown on the display will be cleared. However,
when you turn the unit on again, the previously displayed value will
re-display. All stored values will be retained.
To Set To Metric Mode
1. Turn unit on.
2. Press the [Set] key.
3. Press the [On/Off] key.
4. Press and hold the [Reset] key.
5. Press the [On/Off] key while continuing to
hold the [Reset] key.
6. Press the [Rcl] key to enter Metric Mode.
*Press the [LxW] key to enter Imperial Mode.