Calculated Industries DigiRoller Plus II - Common Questions;Answers

44 — DigiRoller
™
Plus II
Common Questions / Answers
Q: My DigiRoller
™
Plus II won’t register measurements when I roll.
What’s wrong?
A: Make sure you press the [Start/Stop] key to start your measur-
ing (display will no longer show the stop symbol when unit is
in start or measuring mode).
Q: My display shows the words “Lo batt.” What does this mean?
A: When you see the Low Battery Indicator “Lo batt,” replace all
four of the AAA batteries. You may purchase replacement bat-
teries at any store.
Q: My DigiRoller
™
Plus II display is dim and hard to read. How can
I make the display easier to read?
A: You may adjust the LCD contrast control for easier viewing (see
the section “Changing the Display Contrast Level” on page 9 for
instructions on changing the contrast level).
Q: My measurements are coming up (long/short) when I roll on
carpet. What’s wrong?
A: As with all measuring wheels, measurements will vary when
rolling “against the grain” of carpet. Be sure to take this differ-
ence into account when measuring indoors.