Calculated Industries ElectriCalc Pro - Voltage Drop Calculations

Pocket RefeRence Guide
— 37
APPENDIX A —
DEFAULT SETTINGS
After a Clear All ( ), your
calculator will return to the following
settings:
STORED VALUES DEFAULT VALUE
Insulation Rating 60º C
Wire Material Copper
Phase 3Ø
Ambient
Temperature
30º C (86º F)
Volts 240V
Voltage Drop % 3%
Power Factor % 100%
Efciency % 100%
Motor Type Induction
Conduit Type EMT
Fuse/Breaker
Motor Type
Squirrel Cage
non Design E
Overload FLC% 115%
Free Air Mode* Off
* This setting will also return to its default
upon turning the calculator off and back on.
If you replace your batteries or
perform a Full Reset* (Press ,
hold down  and press ) your
calculator will return to the following
settings (in addition to those listed
above):
(cont’d)