2 ) P ress [Subtract/Count] and [M2x]
s i m u l t a n e o u s l y. If you are set-
ting a height, go to step 3. If yo u
a re rolling in a va l u e , the display
will show the rolled value and an
a n nunciator will b e g in fl a s h i n g
(F T-I N for I m p e rial Mode, M M fo r
M e t ric Mode).
3 ) If you do not want to ch a n ge the
units of measure m e n t ,go to step
4 . To ch a n g e the units of mea-
s u re m e n t , p re s s [ M 1 + ] until yo u
re a ch the desired units.
4 ) If you have rolled a va l u e ,p re s s
[ S c a l e ]until the display re t u rns to
z e ro . If you are setting a height,
p ress [Scale] to begi n . The left-
most digit will begin fl a s h i n g .
P re s s :
[ M 1 + ] to increment this digi t
[S u b t r a c t / C o u n t] to decre m e n t
[S c a l e ] to advance to next digi t
[M o d e ] to move back one digi t
C o n t i nue until all digits are set and the
d i s p l ay re t u rns to zero .
2 3 – User’s Guide
To Next Page
Loading...
