value for each digit and move to
the next digit to the ri g h t ) .P re s s
[ M o d e ] to move back one digi t .
If a digit is zero ,s i m p ly press the
[ S c a l e ] key to enter it.
7 ) A d vance through all displaye d
d i gi t s .C o n fi rm the scale entry
by pressing [Rcl] [Scale]. R e m e m -
b e r, Custom Scales remain set
even when the unit is off.To ge t
rid of a Custom Scale, enter a
n e w scale over it or perfo rm a
full re s e t .
Q : When setting a Custom Scale,
the User’s Guide says some-
thing about rolling a known
distance several times. What
does this mean?
A : S t a rting and stopping points are
e s p e c i a l l y critical to the accura c y
of all ro l l i n g .N ow h e r e is this more
t rue than in the setting of a Custom
S c a l e .If you roll a known distance
o n ly once,you may roll it too short
or too long. By rolling a distance
s eve r al times, you can offset the
s t a rt/stop inaccuracies of each
gi v en ro l l .I t ’s equivalent to gi v i n g
3 3 – User’s Guide
To Next Page
Loading...
Need help?
General
