d o wn turning unit on will sw i t ch
unit between Imperial and Metri c
u n i t s .
[Rcl] – Recall key
Used to recall stored va l u e s .W h e n
you pre s s [Rcl] [Rcl], the last va l u e
rolled is displaye d .
[Mode] – Mode key
Used to toggle between the fo l-
l o wing scale modes (in sequence):
1 ) A rch i t e c t u r al (A R C H) ;
2 ) E n gi n e e ring 1 (ENG 1)
3 ) E n gi n e e r ing 2 (ENG 2) ;
4 ) Custom (C U S T O M)
5 ) Count (C O U N T ) .
When in pro g ramming mode, t h i s
key moves the cursor back to the
p r evious field or digi t .
[Scale] – Scale key
Used to toggle between the va ri o u s
scales within each scale mode.
When in the pro g ramming mode
for height or custom scales,this key
m o ves the cursor fo r wa r d to the
n ext field or digit to be pro-
gra m m e d .
5 – User’s Guide
To Next Page
Loading...
