Calorex Variheat AA600 - 8 Warranty Conditions

68
1002595 ISSUE 5 M172 VARIHEAT
VARIHEAT AA SYSTEM OWNER INSTALLATION MANUAL
8.0 WARRANTY CONDITIONS
One year manufacturer’s warranty is valid from e date of commissioning or
18 mons from delivery, whichever is sooner.
Where commissioning is provided in e UK and Ireland, is must be carried
out by factory trained and approved personnel.
The following exclusions apply to e Warranty given by Danerm Ltd. No
claims will be accepted if :
1. The heat pump is installed in any way at is not in accordance wi e
current procedures as defined by Danerm Ltd.
2. The heat pump has not been maintained in accordance wi service
requirements in section 4.1 Regular Planned Maintenance.
3. The heat pump has been worked upon or is adjusted by anyone oer
an a person auorised to do so by Danerm Ltd.
4. The heat pump is incorrectly sized for e application.
5. The water flow rough e machine is outside e specified limits.
6. The water pH level and/or chemical balance is outside e following limits:
7. The heat pump has suffered frost damage.
8. The electrical supply is insucient or in any way incorrect.
9. The fan amps and duct pressure are outside e specified limits.
10. The air flow to and from e machine is outside e specified limits.
11. Corrosion is present due to poor air quality at has not been attended to.
If in doubt or if advice is required please contact e Danerm Group
UK Service Department by calling 01621 856611 (option 4) or emailing
service.department@danerm.com
Note: The Reply Paid Warranty Registration Card must be returned, to ensure
at e correct warranty is given. If you do not find a Registration Card wi
your heat pump please contact e Danerm Group UK Service Department
giving your name, address and serial number of your heat pump. A card will be
sent to you for completion.
Please give MODEL NUMBER and SERIAL NUMBER of your heat pump when
making technical or service enquiries. This will assist in correct diagnosis and
ensure service can be provided wi e minimum delay.
Acidity pH pH 7.2 - 7.8
Total Alkalinity, as CaCO3 ppm 80 - 120
Total Hardness, as CaCO3 ppm 150 - 250
Total Dissolved Solids ppm 1000
Maximum Salt Content ppm 8000
Free Chlorine Range ppm 1 - 2 Domestic
Free Chlorine Range ppm 3 - 6 Commercial
Superchlorination max 30ppm for 24 hrs
Bromine ppm 2 - 5
Baquacil ppm 25 - 50
Ozone ppm 0.9 Max
Maximum Copper Content ppm 1
Aquamatic Ionic Purifier ppm 2 Max