24
Technical Support: 01442 230 800 Email: technical@bpt.co.uk
QUICK START -
MANUAL PROGRAMMING GUIDE
To PROGRAM RECEIVERS carry out the following only
after the entry panel has been programmed
AGATA / LYNEA VIDEO RECEIVERS
While still in programming mode, if programming further receivers
of a different type, please refer to the relevant receiver
programming section.
If programming more Agata / Lynea Video receivers, repeat the
above process on the next receiver. Press prog button quickly
once to exit programming.
For illustration purposes only
AGATA LYNEA
1 Lift handset off
the hook
2 Press Door Release
(KEY) & AUX2 (2 dot)
buttons together until
a video image appears
on screen
3 Check for video image 5 Place handset on hook
At the entry
panel, press
and hold the
call button
(hold until
audible
confirmation
tone) to
program to
this receiver
4
To Next Page
Loading...
