CAME RGSM001 User Manual

Pag. 16 - FA01289M4A - 12/2018 © Came S.p.A.
Technical data
Type RGSM001 RGSM001S
Power supply AC (V) 12 to 30
Power supply DC (V) 12 to 35
Consumption (mA) 200
Radio signal power
869.5MHz (dBm)
14 -
Range of the 869.5MHz radio signal
in a free area (m)
100 -
GSM signal power
EGSM - 900MHz (dBm)
33
GSM signal power
DCS - 1800MHz (dBm)
30
Digital inputs (V DC max) 24
Relay outputs (V DC max) 30
Relay outputs (A max) 1
Maximum cable length
connected to the relay outputs (m)
≤ 100
Maximum cable length
connected to output 485 (m)
≤ 1000
Operating temperature (°C) -20 to 70
Connections
Before making any connections, YOU MUST DISCONNECT
THE MAINS POWER.
If the device is not powered by a Came control panel,
make sure that the supply voltage is provided with pro-
tection devices for currents greater than 1 A.
Where the device is connected to a CAME control panel
equipped with CRP via terminal A-B-GND, power the module
only from terminals 2-10 on the panel itself.
Connecting a single operator
Connect the module to the control board via terminals (10-2)
with a 2 x 0.5 PVC FROR cable ⓐ (length max. 3 m).
Connect the module to the terminals (A-B-GND) with an UTP
CAT5 - AWG24 cable ⓒ and, if the operator is set up to do so,
insert the RSE card ⓔ.
 Please refer to the module compatibility table.
Connecting to several operators
Connect the module to one of the control boards on terminals
(10-2), using a PVC FROR 2 x 0.5 cableⓐ (max. length 3 m) and
make an RS-485 connection (in enter-exit mode) on terminals
(A-B-GND), using a UTP CAT5 - AWG24 cable ⓒ;
maximum length of the UTP CAT5 cable 1000 m.

CAME RGSM001 Specifications

General

Brand	CAME
Model	RGSM001
Category	Control Unit
Language	English