Search
ACCESS
KEYPAD
CALL
Page 3 - Manual FA 014 8 2-E N - 10/2020 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
Error alerts
When shown on the display, this indicates that there is a programming error.
The possible causes are listed below:
High temperature
Non-compliant installation;
Heat sources near the device;
Direct sunlight;
Hardware failure
Ethernet connection
Defective or incorrectly connected CAT5 cable;
Incorrect DATA connection;
Defective switch;
Faulty ethernet port
Error in the configuration
data
Incorrect configuration;
Partial or incomplete programming
Audio or video service not
available
SIP registration failed
Server not reachable or switched off;
Incorrect SIP account
CONFIGURATION AND COMMISSIONING FROM THE DISPLAY
Once the device has been installed, the functions for the device to operate correctly need to be programmed.
Entering programming mode
Press the top-left corner of the display for a few seconds to activate the Settings section.
To Next Page
Loading...
Need help?
General
