CAME XVP F Configuration Manual

System
Date and Time
Network
SIP
Credentials
Access control
Device
Images and logos
Maintenance
Diagnostics
Network
MAC ADDRESS
MODE
IP ADDRESS
Network
Help
CONNECTIONS
Exit
CAMECONNECT
NETMASK
GATEWAY
DNS
Network
Help Exit
KEYCODE
PROVIDER
CONNECTION
STATUS
Enable
Connected
System
Date and Time
Network
SIP
Credentials
Access control
Device
Images and logos
Maintenance
Diagnostics
Network
CONNECTIONS
CAMECONNECT
❼
❽
❾
❿
❶
❷
❸
❹
❺
❻
Page 14 - Manual FA014 82- E N - 10/2020 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
Network settings
CONNECTIONS
❶ Device MAC ADDRESS, cannot be edited.
❷ Choose the type of addressing.
DHCP
The device’s IP address is assigned by the DHCP server.
If the device is configured as the master (serverless system), make sure that the
DHCP server always assigns the same IP address to the device.
STATIC
The device’s IP address is assigned manually.
❸ Enter the device’s IP address.
The device IP address must belong to the same subnet as the router and other
connected devices, in the case of a static IP.
❹ Specify the correct netmask, where different from the default setting.
❺ Specify the default gateway for your network.
❻ Enter a valid DNS address for CAMEConnect connection (only for XVP configured as
MASTER).
Press SAVE or RELOAD at the bottom of the page to save or reload previous data.
Configuring CAMEConnect (MASTER device only)
❼Device keycode.
❽Supplier for the remote calling service (default: xip01.cameconnect.net).
❾ Enable video-entry call VoIP remote control.
❿Connection status.
Press SAVE or RELOAD at the bottom of the page to save or reload previous data.

CAME XVP F Specifications

General

Brand	CAME
Model	XVP F
Category	Intercom System
Language	English