IB0147 Rev. 08 LEFM 200 Modbus User Manual
Cameron's Measurement Systems division is a manufacturer of high quality instrumentation and
control products, selling direct from a Pittsburgh based factory to customers in the U.S. and
through agents and representatives overseas. A complete range of support services is offered. For
additional information or assistance on the application, operation or servicing of the LEFM 200
Modbus, write, call, or visit www.c-a-m.com.
Before performing maintenance procedures, system verification procedures, repair procedures,
and troubleshooting procedures, personnel should receive general training from Cameron.
Contact Cameron’s Measurement Systems division for information on training programs.
Caldon is a trademark of Cameron International Corporation (“Cameron”).
LEFM is a registered trademark of Cameron.
Modbus is a registered trademark of Modbus Organization, Inc.
Copyright © 2010 Cameron International Corporation (“Cameron”). All information
contained in this publication is confidential and proprietary property of Cameron. Any
reproduction or use of these instructions, drawings, or photographs without the express
written permission of an officer of Cameron is forbidden.
All Rights Reserved
Printed in the United States of America
Manual No. IB0147, Rev. 08
December 2010
To Next Page
Loading...
