Campbell CS110 - Page 4

8. CS110 maintenance 25
8.1 Status codes 26
8.2 Changing desiccant 28
8.3 Cleaning the CS110 electrode head 29
8.4 Checking ground integrity 31
8.5 Protecting from corrosion and rust 32
8.6 Recalibration 32
8.7 Troubleshooting 33
9. References 33
Appendix A. Connector pin-outs 34
A.1 Sensor connectors 34
A.2 Power and communication connectors 36
Appendix B. Installing a CM106B tripod 39
B.1 Tripod base 39
B.2 Staking tripod feet 40
B.3 Tripod mast 40
B.4 Tripod grounding 41
Appendix C. Installing a CM110 tripod 43
C.1 Tripod base 43
C.2 Tripod mast 44
C.3 Staking tripod feet 45
C.4 Tripod grounding 46
Appendix D. Mounting the enclosure on a tripod 48
Appendix E. Installing a CM500-series pole 50
E.1 Installation in concrete foundation (withouta pedestal) 50
E.2 Installation with a pedestal 51
E.3 Installation with concrete stud anchors and a pedestal 54
E.4 Pole grounding 55
Appendix F. Mounting the enclosure on a CM500-series pole 56
G. Installing an RA100 remote alarm 59
G.1 Mounting on a flat wall (RA1 option) 59
G.2 Mounting on a pole or tripod (RA2 option) 59
Table of Contents - 4