Campbell CS110 - Power and Communication Connectors

Table A-3: TEMP/RH connector pin number and CR1000
connection
Pin number CR1000 terminal
3 empty
4 SW12V
5 ⏚ (analog ground)
6 G (power ground)
SOLAR connector
This connector is for measuring a pyranometer, barometer, or GPSX16-HVS GPS receiver. The
barometer attaches to this connector using the Barometric Pressure Sensor Cable and must be
housed in a separate enclosure such as the ENC100.
Table A-4: SOLAR connector pin number and CR1000 connection
Pin number CR1000 terminal
1 SE5 or 3H
2
SE6 or 3L (also connects to ground
via a 1 Kohm 0.1% 10 ppm/C resistor)
3 12V
4 C4
5 C3
6 G (power ground)
A.2 Power and communication connectors
POWERconnector
The CS110CBL3-L CS110 Power Cable includes a female connector that mates with the CS110
POWER connector and pigtails that connect with the power supply or an additional data logger.