Table A-1: WIND connector pin number and CR1000 connection
Pin number CR1000 terminal
3 P2
empty empty
5 ⏚ (analog ground)
6 ⏚ (analog ground)
WIND connector
This connector is for measuring a wind speed and direction sensor such as the 05103-L-C Wind
Monitor.
Table A-2: WIND connector pin number and CR1000 connection
Pin number CR1000 terminal
1
SE4 (also connects to ground
via a 1 Mohm 1% 50ppm resistor)
2 ⏚ (analog ground)
3 VX2
4 P1
5 G (power ground)
6 ⏚ (analog ground)
Temp/RH connector
This connector is for measuring a temperature and relative humidity sensor such as the EE181 or
HMP60 sensor.
Table A-3: TEMP/RH connector pin number and CR1000
connection
Pin number CR1000 terminal
1 SE1 or 1H
2
SE2 or 1L (also connects to ground
via a 1 Kohm 0.1% 10 ppm/C resistor)
To Next Page
Loading...
