Campbell CS110 - Installing an RA100 Remote Alarm; Mounting on a Flat Wall (RA1 Option); Mounting on a Pole or Tripod (RA2 Option)

G. Installing an RA100 remote
alarm
The RA100 may be mounted either to a parapet wall using the RA1 Flat Mount option, or to a
fixed pole or tripod using the RA2 Pole Mount option.
G.1 Mounting on a flat wall (RA1 option)
This option provides two stainless-steel brackets for mounting the RA100 on a flat surface. You
will need the following equipment:
l
Drill with 6.5 mm (0.25 in) drill bits
l
Hammer
l
M6 (0.25 in) expansion bolts
l
RA100
l
Flat Mount mounting kit
Mount according to the following directions:
1. Insert the mast extension into the RA100 and bolt into place.
2. Position the RA100 to your liking. Place one bracket over the mast extension, just below the
joint, and mark the wall where it will need to be drilled. Position the second bracket at least
two feet below the top bracket, and do the same.
3. Set the RA100 aside, and drill into the wall using 6.5 mm (0.25 in) drill bits.
4. Hammer M6 (0.25 in) expansion anchors into these holes.
5. Mount the RA100 and tighten the bolts.
G.2 Mounting on a pole or tripod (RA2 option)
This option is used to mount to a pole or tripod with a 6.1 cm (2.4 in) outer diameter (OD).