Appendix C. Installing a CM110
tripod
Contact local utility providers to locate any buried utilities prior to installation. Assemble the
tripod so that the top is 2.54 m (100 inches) from the ground.
First, prepare the area where the tripod will be installed. The tripod requires an area
approximately 2.1 m (7 ft) in diameter. See Site selection (p. 7). Next, using a sledge hammer or
fence post driver, drive the grounding rod into the ground where the center of the tripod is to be
located.
C.1 Tripod base
1. Stand the tripod base on end and rotate the feet perpendicular to the legs.
2. Each leg has a slide collar and T-knob with a spring-loaded pin that locks into holes located
on the underside of the leg, as shown in the following image. Extend each leg until the pin
clips into the fourth hole from the foot. Tighten the T-knob. Extending the legs as
described puts the feet on a circle with a radius of approximately 102 cm (40 inches).
To Next Page
Loading...
