10. Adjust the lower nuts on each J-bolt to plumb the pole. Lock the lower nuts together using
two wrenches. Tighten the upper nuts to secure the pedestal to the J-bolts.
E.3 Installation with concrete stud anchors and a
pedestal
If using a preformed concrete pad, you may still use the pedestal J-bolt kit by installing stud
anchors into the concrete.
1. Set the pedestal on the concrete and mark with a pencil where the holes will need to be
drilled.
2. Drill the three holes 3 1/4 inches deep using a hammer drill with a 1/2-inch diameter
carbide-tipped drill bit.
3. Clean out each hole of all debris and dust using a wire brush, compressed air, or vacuum.
4. Thread a nut onto the threaded end of each concrete stud anchor so the top of the nut is
flush with the top of the concrete stud anchor.
5. Insert the concrete stud anchors, clipped end first, into the predrilled holes.
To Next Page
Loading...
