Appendix F. Mounting the
enclosure on a CM500-series
pole
A system ordered with this option will be shipped with brackets, metal bands, and mounting
hardware needed to secure the enclosure. The metal bands are routed through the brackets and
then around a vertical pole. They are anchored in place using screw clamps.
Mount the enclosure to the mast opposite the CS110, with the top of the enclosure 26 inches (66
cm) above the ground.
1. Position a bracket at the top of the enclosure as shown in the following figure. Secure it
with a bolt, washer, and locknut at each end. Attach the lower bracket in the same manner,
rotating the bracket so it extends below the enclosure.
To Next Page
Loading...
