Appendix A. Connector pin-
outs
Figure A-1 (p. 34) shows the numbering for the connectors from the solder-cup side of the cabled
connector. The circular connectors are Mini-Con-X type from Conxall. Campbell Scientific fills the
backshell of the connector with a relatively thick epoxy to seal and provide strain relief.
Figure A-1. Pin numbers for 6-pin and 9-pin connectors
A.1 Sensor connectors
The corresponding terminals listed in the tables are needed for programming the sensors.
RAIN connector
This connector is for measuring a tipping bucket rain gage such as the TE525.
Table A-1: WIND connector pin number and CR1000 connection
Pin number CR1000 terminal
1 empty
2 empty
To Next Page
Loading...
