Campbell CS110 - Page 52

To Next Page

To Previous Page

NOTE:

The tripod includes a lightning rod. DONOT install the lightning rod, as it will adversely affect

CS110 measurements.

Main Page

Please Read First2
Table of Contents3
Introduction6
Precautions6
Lightning Safety6
Initial Inspection7
Accessories7
Overview8
Specifications10
Installation11
Site Selection12
Installing the CS11013
Power Considerations13
Connecting to AC Power14
Seal Cable Connectors14
Programming14
CS110() Instruction14
Cs110Shutter Instruction15
Internal Relative Humidity Sensor Programming15
Sensor Programming15
Operation17
Measurement Details17
CS110 Lightning Detection Example20
Lightning Warning Levels21
All Clear22
Caution or Lightning Watch22
Alarm or Lightning Warning23
Lightning Warning Logic23
Factory Calibration of the CS11025
Site Correction27
CS110 Maintenance30
Status Codes31
Changing Desiccant33
Cleaning the CS110 Electrode Head34
Checking Ground Integrity36
Protecting from Corrosion and Rust37
Recalibration37
Troubleshooting38
References38
Appendix A. Connector Pin-Outs39
Sensor Connectors39
Power and Communication Connectors41
Appendix B. Installing a CM106B Tripod44
Tripod Base44
Staking Tripod Feet45
Tripod Mast45
Tripod Grounding46
Appendix C. Installing a CM110 Tripod48
Tripod Base48
Tripod Mast49
Staking Tripod Feet50
Tripod Grounding51
Appendix D. Mounting the Enclosure on a Tripod53
Appendix E. Installing a CM500-Series Pole55
Installation in Concrete Foundation (Without a Pedestal)55
Installation with a Pedestal56
Installation with Concrete Stud Anchors and a Pedestal59
Pole Grounding60
Appendix F. Mounting the Enclosure on a CM500-Series Pole61
Installing an RA100 Remote Alarm64
Mounting on a Flat Wall (RA1 Option)64
Mounting on a Pole or Tripod (RA2 Option)64
Appendix H. Installing the SG000 Strike Guard65
Appendix I. CS110 as a Slow Antenna66
Slow Antenna Response in Frequency Domain66
Slow Antenna Response in Time Domain67
Slow Antenna Programming69
Calibration70
Appendix J. Site Calibration Using Transfer Standard on Cm310S72
Site Calibration73
Transfer Standard Installation76
Site Calibration Cautions80
Limited Warranty85

Campbell CS110 - Page 52

Table of Contents

Related product manuals