2020
ADJUSTMENT OF THE OVEN BURNER MINIMUM
In the minimum position the ame must have a length of about 4 mm and must remain lit
even with a brusque passage from the maximum position to that of minimum.
The ame adjustment is done in the following way:
• Remove the control panel (g. 2.8). To do that, rstly remove the control knobs and
then unscrew the no.11 xing screws (no.2+2 “A” on the sides & no.3 “B” at the bottom
of the control panel, and no.4 “C” at the top of the oven casing). Release the control
panel from the oven (it is mechanically anchored at the top) as indicated by the arrows
in g. 2.8.
Pay special care to avoid any damages to the control panel and to prevent injuries to
yourself.
• Remount the knob and turn on the oven burner by setting the thermostat knob on
maximum position (“10” or “240” or
Max
).
• Remove the knob and unscrew the by-pass screw “G” (g. 2.7) about three times by
using a small at screwdriver.
• Remount the knob and let the oven heat up for about 15 minutes, then bring the knob
to the minimum position (“1” or “130”) to operate the thermostat by-pass.
• After having removed the knob again and being very careful not to turn the thermostat
rod, slowly screw the by-pass screws “G” (g. 2.7) until you obtain a ame of 3-4 mm
in height.
• After having completed the
regulation, ret the control panel
and knobs correctly in place
operating in reverse order (g.
2.8).
N.B. For G30/G31 (LPG) the by-pass
screw must be xed thoroughly.
Fig. 2.7
G
Fig. 2.8
To Next Page
Loading...
