Canon image RUNNER 3245 - Directly Sending Faxes from the Machine; Sending Faxes from a Computer Via the Machine; Netware Network Setup Procedures; Appletalk Network Setup Procedures

Operations Required to Use the Machine
1-9
1
Flow of Settings
Directly Sending Faxes from the Machine
The following operations and settings are required to directly send faxes with the machine.
1
Specify the settings required for sending faxes.
See “Fax Settings,” on p. 9-2.
Sending Faxes from a Computer via the Machine
The following operations and settings are required to send faxes from a computer via the machine.
For information on the system requirements for using this function, see “Printing or Sending a Fax from a
Computer,” on p. 3-2.
1
Connect the machine to a computer.
To connect via a network
See “Connecting to a Network,” on p. 4-3.
See “Interface Settings,” on p. 4-9.
See “Communication Environment Setup,” on p. 4-11.
To connect via USB*
See “Connecting to a USB Interface,” on p. 4-5.
*In this case, proceed to step 3 after connecting the machine.
2
Set the machine for the type of network you are using.
For a TCP/IP network
See “TCP/IP Network Setup Procedures,” on p. 5-2.
See “Protocol Settings,” on p. 5-3.
For a NetWare network
See “NetWare Network Setup Procedures,” on p. 6-2.
See “Protocol Settings,” on p. 6-3.
For a NetBIOS network
See “NetBIOS Network Setup Procedures,” on p. 7-2.
See “Protocol Settings,” on p. 7-3.
For an AppleTalk network
See “AppleTalk Network Setup Procedures,” on p. 8-2.
See “Protocol Settings,” on p. 8-3.