Canon image RUNNER 3245 - Using the Machine as a Scanner

Operations Required to Use the Machine
1-11
1
Flow of Settings
3
Install the printer driver in the computer to use.
See Chapter 10, "Before Printing from Computers."
Using the Machine as a Scanner
The following operations and settings are required to use the machine as a scanner.
If you are using a NetWare network, NetBIOS network, or AppleTalk network, you cannot use this function.
1
Connect the machine to the network.
See “Connecting to a Network,” on p. 4-3.
See “Interface Settings,” on p. 4-9.
2
Set the machine to use the TCP/IP network.
See “TCP/IP Network Setup Procedures,” on p. 5-2.
See “Protocol Settings,” on p. 5-3.
3
Install the software for specifying scanner settings (Network ScanGear) into the computer
connected to the machine.
See Chapter 12, "Before Using the Remote Scan Function."