Protocol Settings
5-25
5
Using a TCP/IP Network
If you set the startup time of the machine's network function by following the procedure in “Startup Time
Settings,” on p. 5-29, execute the PING command only after the time set as the startup time passes.
If you connect the machine to a switching hub, the machine may not be able to connect to a network even
though your network settings are appropriate. This problem may be resolved by delaying the startup of
network communications for the machine. See “Startup Time Settings,” on p. 5-29 for information on how
to set up the startup time.
3
On the TCP/IP Settings screen, press [SNTP Settings]
→
check the following.
After pressing [NTP Server Check], if <OK> is displayed, time synchronization is working correctly via
SNTP.
If <Error> is displayed, check the settings for [NTP Server Address] set in step 3 of see “Settings Common
to TCP/IPv4 and TCP/IPv6,” on p. 5-17.
Even if you perform [NTP Server Check], time settings are not updated. Check that communications are
possible between the machine and the NTP server.
Confirming TCP/IPv6 Settings
The following is the procedure for confirming that the TCP/IPv6 network connections are properly
set.
1
On the TCP/IP Settings screen, press [IPv6 Settings]
→
[PING Command].
2
In [PING Command], check the following.
•
•
To Next Page
Loading...
