Canon image RUNNER 3245 - Page 88

Protocol Settings
5-28
5
Using a TCP/IP Network
If the POP server does not support SSL encryption, data is not encrypted when [On] is selected for <Allow
SSL (POP)>.
In order to select [On] for <Allow SSL (POP)> to allow SSL transmission, it is necessary to generate a key pair
in advance. For instructions on how to generate a key pair, see e-Manual > Network.
3 Specify the mail server for sending e-mail/I-faxes.
If you are using an SMTP server that requires POP before SMTP (method for authen-
ticating users who have logged in the POP server before sending e-mail):
In [SMTP Server], enter the IP address or name of the SMTP server using the keyboard on the
touch panel display.
Press [On] for <POP Authentication before Sending> → press [Off ] for <SMTP Authentication (SMTP
AUTH)>.
If you are using an SMTP server that requires SMTP Authentication (method for
authenticating users who have logged in the SMTP server before sending e-mail):
In [SMTP Server], enter the IP address or name of the SMTP server using the keyboard on the
touch panel display.
Press [On] for <SMTP Authentication (SMTP AUTH)> → press [Off] for <POP Authentication before
Sending>.
In [User], enter the user name used for logging in to the SMTP server. If you are using a Microsoft
SMTP server, enter the user name in [User] using the following format: user name@domain name.
In [Password], enter the password used for logging in to the SMTP server.
To encrypt data to be sent using SSL, select [On] for <Allow SSL (SMTP Send)>.
•
•
●
☐
●
☐