Handling rolls
4. Specify the type and length of the paper .
How the printer operates after the paper is fed varies depending on the setting for automatic
detection of the remaining roll paper , as well as the barcode printed on rolls.
Automatic Detection of the
Remaining Roll Paper
Barcodes
Printer Operation After the Paper is Fed
Printed The type and amount of paper left is
automatically detected based on the barcode
printed on the roll.
There is no need to specify the type and length
of the paper .
On
Not printed Y ou must specify the type and length of the
paper . A menu for selection of the paper type
and length is automatically shown on the Display
Screen .
( → P .124)
( → P .125)
PrintedOf f
Not printed
Y ou must specify the type of paper .
( → P .124)
5. Close the Roll Paper Unit Cover .
6. If the edge of the roll is bent or soiled, cut the edge of the paper .
1. Press the Online button to bring the printer of ine.
2. Press ▲ or ▼ to feed the roll paper to the position for cutting.
3. Select Y es in Paper Cutting on Printer Menu, and then press the OK button. ( → P .129 )
Handling Paper 121
To Next Page
Loading...
Need help?
General