The printer stops during a print job
The printer stops during a print job
An error message is shown on the Display Screen ....................................................................................... 100
The printer ejects blank, unprinted paper ......................................................................................................... 100
An error message is shown on the Display Screen
An error message is shown on the Display Screen
Cause Corrective Action
An error message is displayed during printing. Check the error message and take action as necessary.
(See "Error Messages.") →P.139
The last portion of roll paper was used during a print job, and paper
could not be advanced because the trailing edge is taped to the roll.
Remove the used roll and insert a new roll.
(See "Removing the Roll from the Printer.") →P.14
(See "Removing Rolls From the Roll Holder.") →User's Guide
(See "Loading and Printing on Rolls.") →User's Guide
The printer ejects blank, unprinted paper
The printer ejects blank, unprinted paper
Cause Corrective Action
The leading edge of the roll paper was
cut to straighten it.
The leading edge of rolls may be cut to straighten it if Trim Edge First is set to a value other
than Off in the Control Panel menu.
(See "Cutting the Leading Edge of Roll Paper Automatically.") →User's Guide
The Printhead nozzles are clogged. Print a test pattern to check the nozzles and make sure the Printhead is in good condition for
printing.
(See "Checking for Nozzle Clogging.") →User's Guide
A print job was received from an in-
compatible printer driver.
Use the correct imagePROGRAF printer driver for the printer and try printing again.
The printer is damaged. Contact your Canon dealer for assistance.
An error message is shown on the Display Screen
iPF6400
Basic Guide
Troubleshooting The printer stops during a print job
100
To Next Page
Loading...
Need help?
General
