PaprWidth Mismatch
PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu is
set to Pause, the width of the loaded roll does not
match the width specified in Fit Roll Paper Width in
the printer driver.
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quali-
ty.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.") →P.14
(See "Removing Rolls From the Roll Holder.") →User's Guide
2.
Replace with paper of the width configured in the printer driver.
(See "Loading Rolls on the Roll Holder.") →P.9
(See "Loading Rolls in the Printer.") →P.11
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select Fit
Roll Paper Width in the printer driver matches the width of the roll loaded in the
printer, and then try printing again.
Paper size not detected.
Paper size not detected.
Cause Corrective Action
Paper has been loaded askew, or warped paper has been loaded. Press the OK button and reload the paper.
(See "Loading Rolls in the Printer.") →P.11
(See "Loading Sheets in the Feed Slot.")
→P.17
If "Not finished printing. Finish printing
remaining jobs?" is displayed on the Dis-
play Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
If this error recurs after you reload the roll,
remove the Roll Holder from the printer,
push the roll firmly in until it touches the Roll
Holder flange, and reload the Roll Holder in
the printer.
(See "Loading Rolls on the Roll Holder.")
→P.9
Insufficient paper for job
Insufficient paper for job
Cause Corrective Action
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.
Press ▲ or ▼ to select Print, and then press the
OK button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.
Press ▲ or ▼ to select Change Paper, and then
press the OK button.
Change the Paper Source of the printer driver,
or replace the roll with a roll that has enough pa-
per for the print job, and then print.
(See "Removing the Roll from the Printer.")
→P.14
(See "Loading Rolls in the Printer.")
→P.11
PaprWidth Mismatch
iPF6400
Basic Guide
Error Message Messages regarding paper
122
To Next Page
Loading...
Need help?
General
