Canon iP4500 - Operator Call Error (Alarm LED Blinking in Orange)

5
3. ERROR DISPLAY
Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor.
3-1. Operator Call Error (Alarm LED Blinking in Orange)
Alarm LED
blinking
Error Corrective action Remarks
No paper in the rear tray.
[1000]
Set the paper in the rear tray, and press
the Resume/Cancel button.
No CD / DVD tray. [1001] Set the CD / DVD tray, and press the
Resume/Cancel button.
No paper in the cassette.
[1003]
Set the paper in the cassette, and press
the Resume/Cancel button.
2 times
No CD or DVD. [1002] Set a CD or DVD in the CD / DVD tray
(which is ejected at error occurrence), and
inset the CD / DVD tray in the proper
position. Then, press the Resume/Cancel
button.
Paper jam. [1300] Error during paper feeding
from the rear tray
Paper jam in the rear guide.
[1303]
Error in the duplexing
transport unit
Paper jam in the under
guide. [1304]
Remove the jammed paper, and press the
Resume/Cancel button.
Error during paper feeding
from the cassette
3 times
Front door close error.
[1250]
Open the paper output tray. The error is indicated if the
paper output tray is closed at
start of a print job, or while a
print job is being performed.
No ink. [1600] Replace the applicable ink tank, or press
the Resume/Cancel button to clear the
error without ink tank replacement.
When the error is cleared by
pressing the Resume/Cancel
button, ink may run out
during printing.
4 times
Ink tank not installed. [1660] Install the applicable ink tank(s) properly,
and confirm that the LED's of all the ink
tanks light red.
5 times - Print head not installed, or
not properly installed.
[1401]
- Print head temperature
sensor error. [1403]
- Faulty EEPROM data of
the print head. [1405]
Install the print head properly.