7
11 times Failed in automatic print
head alignment. [2500]
Press the Resume/Cancel button.
- If paper is being fed at error occurrence,
the error is indicated after the paper is
ejected.
- If the error occurs, the print head
alignment values are not changed.
- After exit from the error by the
Resume/Cancel button, the automatic
print head alignment will not be re-done.
The error will occur (a) when
the print head alignment
pattern is not printed due to
no ink or non-ejection of ink,
(b) when the sensor's AD
value is incorrect, or (c)
when the paper is shorter
than the specified length.
13 times The remaining ink amount
unknown. [1683]
Replace the applicable ink tank with a new
one, and close the scanning unit (printer
cover).
Printing with a once-empty ink tank can
damage the printer.
To continue printing without replacing the
ink tank(s), press the Resume/Cancel
button for 5 sec. or longer to disable the
function to detect the remaining ink
amount. After the operation, it is recorded
in the printer EEPROM that the function to
detect the remaining ink amount was
disabled.
The error is indicated when
raw ink is detected but the
dot count number exceeds
the threshold of complete
exhaustion of ink
14 times Ink tank not recognized.
[1684]
A non-supported ink tank is installed (the
ink tank LED is turned off). Install the
supported ink tanks.
15 times Ink tank not recognized.
[1410 to 1414]
An error occurred in an ink tank (the ink
tank LED is turned off). Replace the ink
tank(s).
Each error code corresponds to each ink
tank, from left (the opposite side of the
home position) to right, respectively. Error
code 1410 is for the leftmost ink tank
(PGI-5BK).
Ink tank positioning (from left
to right): BK, PigBK, Y, M, C
16 times No ink. [1688] Replace the empty ink tank(s), and close
the top cover.
Printing with an empty ink tank can
damage the printer.
To continue printing without replacing the
ink tank(s), press the Resume/Cancel
button for 5 sec. or longer to disable the
function to detect the remaining ink
amount. After the operation, it is recorded
in the printer that the function to detect the
remaining ink amount was disabled.
The error is indicated when
"no raw ink" is detected and
when the dot count number
exceeds the threshold of
complete exhaustion of ink.
19 times Non-supported hub An unsupported USB hub is connected.
Remove the hub.
To Next Page
Loading...
