sec.) has occurred.
##779 TX After transmitting EOR-MPS in ECM
transmission, ERR has been received.
- Try a higher transmission level.
##780 TX After transmitting EOR-EOM in ECM
transmission, no significant signal has been
received, and re-transmission of the procedure
signal has been attempted the number of
specified times but failed.
- Increase the transmission level of the
receiving machine.
##782 TX After transmitting EOR-EOM in ECM
transmission, DCN has been received.
- Increase the transmission level of the
receiving machine.
##783 TX After transmitting EOR-EOM in ECM
transmission, re-transmission of the procedure
signal has been attempted the number of
specified times but failed, or T5 time-over (60
sec.) has occurred.
- Increase the period of time of the T5
time-over.
##784 TX After transmitting EOR-EOM in ECM
transmission, ERR has been received.
- Try a higher transmission level.
##785 TX After transmitting EOR-EOP in ECM
transmission, no significant signal has been
received, and re-transmission of the procedure
signal has been attempted the number of
specified times but failed.
- Try a higher transmission level.
- Increase the transmission level of the
receiving machine.
##787 TX After transmitting EOR-EOP in ECM
transmission, DCN has been received.
- Try a higher transmission level.
##788 TX After transmitting EOR-EOP in ECM
transmission, re-transmission of the procedure
signal has been attempted the number of
specified times but failed, or T5 time-over (60
sec.) has occurred.
- Increase the period of time of the T5
time-over.
##789 TX After transmitting EOR-EOP in ECM
transmission, ERR has been received.
- Try a higher transmission level.
##790 RX After receiving EOR-EOP in ECM reception,
ERR has been transmitted.
- Increase the transmission level of the
sending machine.
##791 TX / RX During the ECM mode procedure, a signal other
than a significant one has been received.
##792 RX In ECM reception, PPS-NULL between partial
pages has not been detected.
- Increase the transmission level of the
sending machine.
##793 RX During high-speed signal reception in ECM, no
effective frame has been detected, and a time-
over has occurred.
- Try a higher transmission level.
- Increase the transmission level of the
sending machine.
<1. TROUBLESHOOTING>
To Next Page
Loading...
