Configure the IPsec settings on a workstation or a print server
When to do
After the IPsec configuration on the controller.
Pre-requisites
Log on the workstation with the Administration rights.
Purpose
Complete the IPsec configuration for a secure connection between the printer/copier system and
a workstation.
On the workstation, perform the 7 following actions:
1-
Add the security snap-in
on page 122
2-
Create the security policy
on page 123
3-
Create the filter list
on page 124
4-
Define the filter actions and security negotiation
on page 126
5-
Define the security rule
on page 127
6-
Assign the security policy
on page 129
7-
Customize the IPsec settings
on page 130
NOTE
The procedure below shows the configuration steps on Windows server 2008 for an Océ
ColorWave 300 system.
The procedure is similar on other Operating Systems (Windows Server 2003, Windows XP,
Windows Vista, Windows 7) and for other Océ printers.
Add the security snap-in
Procedure
1.
In the 'Start' - 'Run' window, enter 'mmc' to open the management console
2.
In the top menu select 'File' - 'Add/Remove Snap-in'
Configure the IPsec settings on a workstation or a print server
Chapter 6 - Security on Océ ColorWave 500 and Océ ColorWave 700
355
To Next Page
Loading...
