Check 6: Cannot Find Printer on Check Printer Settings Screen
During Wired LAN Setup (Windows)
Does your security software's firewall or computer operating system
interfere with network communications setup?
The firewall of your security software or operation system for computer may limit communication between
the printer and your computer. Check the firewall setting of your security software or operation system or
the message shown on your computer.
If firewall interferes with setup:
• If message appears:
If a message appears warning that Canon software is attempting to access the network, set the
security software to allow access.
After allowing the software to access, click Redetect on the Check Printer Settings screen to
redetect the printer.
If the printer is found, follow the instructions on the screen to continue to set up network
communication.
• If no message appears:
Cancel the setup, and then set the security software to allow Canon software below to access the
network.
Setup.exe or Setup64.exe in the win > Driver > DrvSetup folder on the Setup CD-ROM
After setting the security software, redo the network communication setup from the beginning.
Note
• For more on firewall settings of your operating system or security software, see instruction manual or
contact its manufacturer.
If firewall settings are not causing problem:
Go to check 7.
Check 7: Cannot Find Printer on Check Printer Settings Screen During Wired LAN Setup (Windows)
595
To Next Page
Loading...
Need help?
General
