Canon varioPrint 130 - Change the Finishing Method

Change the Finishing Method
Introduction
The required finishing method is usually set in the printer driver. However, you can change the
finishing method on the control panel.
Depending on the configuration of your system you can change the following finishing methods,
for example.
• Number of staples.
• Number of punch holes.
• The location of the staples or punch holes.
NOTE
You cannot change this setting for the active print job
.
Procedure
1.
On the control panel, touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs], or go to a
DocBox.
2.
Touch the job you want to change.
3.
Touch [Properties], or double-tap the job to open the [Properties] window.
4.
Touch the [Binding] button.
5.
Make the required changes.
6.
Press [OK].
Change the Finishing Method
180
Chapter 9 - Carry Out Print Jobs
Canon varioPRINT DP line