Canon varioPrint 130 - Change the [Job] Settings; Change the Number of Sets

Change the [Job] Settings
Change the Number of Sets
Introduction
Follow the procedure below to change the number of sets for a job that is present in the list of
[Waiting jobs] or [Scheduled jobs], or in a DocBox.
NOTE
You cannot change this setting for the active print job
.
Procedure
1.
On the control panel, touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs], or select a
DocBox.
2.
Touch the job you want to change.
3.
Touch [Properties], or double-tap the job to open the [Properties] window.
4.
Touch the [Number of sets] button.
5.
Enter the desired number of sets (between 1 and 65,000).
If necessary, touch the arrow button <- to correct the previous entry, or touch [Cancel] to close
the numerical keyboard without saving the changes.
6.
Press [OK].
Change the [Job] Settings
182
Chapter 9 - Carry Out Print Jobs
Canon varioPRINT DP line