Restore Default Settings
173
8
Appendix
The reset switch is located in a recessed area. Push
the switch using the tip of a slender object such as a
clip.
All settings of the camera, except for the date and
time, are restored to factory default settings.
For dome case attachment, see the “Installation
Guide” included with the camera.
3
Turn on the power while pushing the reset switch, and
keep pushing the reset switch for 5 seconds or more.
Important
If the reset switch is pushed, network-related settings will also
be restored to factory default settings including the camera's IP
address, subnet mask, default gateway address, etc.
Accordingly, you can no longer operate the camera from the
PC you were using to connect to the camera before. When
initializing the camera, use the “VB Initial Setting Tool” installed
in your PC to set an IP address appropriate for the environment
in which the camera is used (See “Performing Initial Settings for
the Camera” (p. 28)).
Reset Switch
VB-H630VE/VB-M620VE
Reset Switch
4
For VB-H630VE/VB-H630D/VB-M620VE/VB-M620D,
attach the dome case.
VB-H630D/VB-M620D
Reset Switch
Reset Switch
To Next Page
Loading...
