Canon VIXIA HF M30 User Manual

Video

65
NOTES
• If the degree of camcorder shake is too high, the image stabilizer may
not be able to fully compensate.
• Powered IS is not available in mode.
• For surveying and following shots, when you pan the camcorder from
side to side or tilt it up and down, we recommend setting the IS mode
to [P Dynamic] or [Q Standard].
Pre-Recording
The camcorder will start recording 3 seconds before you press
g, ensuring you do not miss important shooting opportuni-
ties. This is especially useful when it is difficult to predict when to start
recording.
Powered IS
When shooting video, you can use Powered IS to make the image
stabilization even more powerful. Powered IS is most effective when
you are stationary and zooming in on far subjects using high zoom
ratios (the more you approach the telephoto end). Holding the LCD
panel with your left hand will add to the stability of the shot.
Press and hold Y as long as
you want to activate Powered IS.
• Z appears in yellow, while
Powered IS is activated.
• You can change the operation of the
Y button (long press or
toggle on/off) with the
7 8
[POWERED IS Button] setting.
Operating modes:

Canon VIXIA HF M30 Specifications

General

Digital zoom	300 x
Optical zoom	15 x
Image stabilizer	Yes
Focal length range	4.1 - 61.5 mm
Focal length (35mm film equivalent)	39.5 - 592.5 mm
Sensor type	CMOS
Total megapixels	2.99 MP
Optical sensor size	1/4 \
Display diagonal	2.7 \
Camera shutter speed	1/2000 - 1/500 s
Internal memory	8000 MB
Power consumption (typical)	3.5 W
USB 2.0 ports quantity	1
Compatible memory cards	SD, SDHC

Weight and Dimensions

Weight	320 g