CanyCom CM141 - Page 36

-27-
Operation 4
3. Move cutting height adjust lever to a desired
height.
4. Move rotary clutch lever to [ON] to start
cutting blade.
5331M-0403-010E
Cutting Height
Adjust Lever
5331M-0403-030E
Cutting Rotary
Clutch Lever
5. Drive machine forward to cut.
• When cutting with this machine for the rst
time, start on a at surface. Drive slowly
and in an overlapping pattern.
• If load to cutting blade is high, drive slowly,
or cut twice.
• Safety feature: engine stops automatically if
operator leaves seat while cutting blade is
rotating.
NOTE
5331M-0403-051E
Drive Lever