Transmission Oil
1. Park machine on a level ground.
2. Visually inspect amount and condition of oil.
3. Check if oil level is between upper and lower
limits. Fill oil if needed.
4. Change oil if oil is too dirty.
• Oil to Use: Page 34.
• Oil Capacity: Page 34.
NOTE
1. Park machine on a level ground.
2. Have an appropriate oil drain pan.
3. Open rear cover.
4. Remove oil plug.
5. Remove drain plug and drain oil.
6. Put drain plug back in place.
7. Fill specied amount of correct oil into ller.
8. Put ller cap back in place.
9. Close rear cover.
To Next Page
Loading...
