CanyCom CM141 - Engine; Chassis

Maintenance
-30-
5
• Perform a pre-startup inspection (PSI) before each use, a monthly inspection once a
month, and a yearly inspection once a year.
• Some maintenance procedures described below may require special knowledge
or tools and instruments. Contact your CANYCOM representative to perform such
procedures.
Chassis
Item Description
Schedule
Note
PSI
Mon
Year
Drive Train
Tires
Tires shall be inated to the specied
pressure.
√ √ √
Page 44
Tires and wheels shall be free of crack,
damage, or uneven wear.
√ √
Wheel bolts shall not be loose or missing.
√ √ √
Wheel bearings do not exhibit excessive play
and no irregular noise or overheating shall
be observed.
√ √
Transmission
Irregular noise or overheating shall not be
observed when moving forward or backward.
√ √
There shall not be oil leaks in or around
transmission.
√ √
HST
HST shall perform normally.
√ √ √
Hydraulic uid shall be lled to a proper
level and shall be clean and free of dirt or
contamination.
√ √
Page 46
Lever shall not be loose or have excessive
play.
√ √
V-belt
Belt tension shall be properly adjusted.
√ √
Belt shall be free of damage or excessive
wear.
√ √
Brake
Brake shall work properly.
√ √ √
Page 48
Parking Brake
Parking brake shall be able to hold the
machine on a 15-degree slope.
√ √
Steering
Wheel
Turn steering wheel right and left; front
wheels shall turn accordingly.
√ √
Rods, Links,
and Wires
Rods, links, and wires in linkage shall be free
of deformation or damage.
√ √
Connections shall be free of looseness,
excessive play, or missing cotter pins.
√ √