Caple C950I - Booster Function Usage; Using the Timer Functions

11
Booster function
The booster function [ B ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones work for 10 minutes with an ultra-high power.
The booster is used for example to heat up rapidly big quantities of water, for cooking noodles etc.
 Start / stop the booster function:
Action Control panel Display
Zone selection press key [ 0 ] from the zone [ 0 ] and control light on
Start up the booster press key [ B ] [ P ]
Stop the booster slide on the “slider” [ P ] to [ 0 ]
or press on [ B ] [ 9 ]
 Power management:
The whole cooking hob has a maximum power limit. When the booster function is activated, to
stop the hob exceeding the maximum power, the electronic system automatically reduces the
power level of another heating zone. The display will flash on [ 9 ] for a few seconds and then
shows the maximum power allowed :
Heating zone selected The other heating zone: (example: power level 9)
[ P ] is displayed [ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Timer
The timer is able to be used simultaneous with all 4 heating zones and this can be with different
time settings (from 0 to 99 minutes) for each heating zone.
 Setting and modification of the cooking time :
Example for 16 minutes at power 7 :
Action Control panel Display
Zone selection press display [ 0 ] selected [ 0 ] and indicator light on
Select the power level slide on the “slider “ to [ 7 ] [ 7 ]
Select « Timer » press display [ CL ] [ 00 ]
Set the units slide on the “slider “ to [ 6 ] [ 0 fixed ] [ 6 flashing ]
Validate the units press display [ 06 ] [ 0 flashing] [ 6 fixed ]
Set the tens slide on the “slider “ to [ 1 ] [ 1 flashing] [ 6 fixed ]
Validate the tens press display [ 16 ] [ 16 ]
The time is confirmed and the cooking starts.
 To stop the cooking time:
Example for 13 minutes at power 7 :
Action Control panel Display
Zone selection press display [ 0 ] selected [ 0 ] and indicator light on
Select « Timer » press key [ 13 ] [ 13 ]
Deactivate the units slide on the “slider “ to [ 0 ] [ 1 fixed ] [ 0 flashing]
Validate the units press display [ 10 ] [ 1 flashing] [ 0 fixed ]
Deactivate the tens slide on the “slider “ to [ 0 ] [ 0 flashing] [ 0 fixed ]
Validate the tens press display [ 00 ] [ 00 ]
 Automatic stop at the end of the cooking time:
As soon as the selected cooking time is finished the timer displays a flashing [ 00 ] and a alarm rings.
To stop the sound and the flashing press the key [ 00 ].