4
Installation of the multizones
Installation
Unpack all the components.
The installation and connection of the appliance must be done by approved specialists. The
manufacturer cannot be held responsible for damage caused by the installation or any
connection errors.
The appliance must be installed into a kitchen unit and an adapted and approved work surface.
This domestic appliance is to be used exclusively for the cooking of food, it must not be used
for any other domestic, commercial or industrial use.
Remove all labels and self-adhesives from the ceramic glass.
Do not transform or modify the appliance.
The cooking zones and the control panel should not be used as a support or worktop.
The appliance must be grounded and connected conforming to all local standards.
Do not use any extension cables to connect it.
The appliance cannot be used above a dishwasher or a tumble-dryer as steam may damage the
electronic components.
Please refer to the worktop manufacturer for the minimum spacing required between each
zone cut out to maintain the required supporting strength.
Ventilation
Important: the cooling system needs adequate airflow.
Ensure you adhere to the ventilation space shown in the below diagrams:
To Next Page
Loading...
