5.2b INTERCOM WITH CHANNELS “A” AND “B”
Start multi-party conversations using Intercom Channels “A” and “B”. This mode is
suitable for 2, 3 or 4-way calls.
PAIRING INTERCOM CHANNELS “A” AND “B”
Pairing a channel will replace any existing paired device on that Channel with the
newly paired device.
If you have purchased the PACKTALK DUO, both units are factory-paired and congured
to communicate via Channel “A”. If for any reason you have to pair them again, OR if you
wish to pair a dierent unit to make Intercom calls, proceed as follows:
There are three ways to pair Intercom (IC) Channels “A” and “B”:
g
OPTION 1: Via the Cardo SmartSet App
Â
OPTION 2: Advanced Features Menu
1. Make sure your unit is in Bluetooth Intercom mode and in Standby.
2. Double-tap
Z
and choose the Advanced Features Menu (see 3.3).
3. Select either “Pair Intercom Channel A” or “Pair Interom Channel B”.
☛
OPTION 3: Manual Pairing
1. Check that all units are in Standby.
2. To pair IC Channel A – press
v
for 5 sec. until the RED LED begins ashing rapidly.
To pair IC Channel B – press
v
for 5 sec. until the RED LED begins ashing rapidly.
Then double-tap
v
.
A ashing BLUE LED indicates Channel “B” pairing mode.
3. Enter IC Pairing mode on the second unit following its user manual. Both units
will now be in Intercom Pairing mode.
4. After a few seconds, both units will show a solid LED for 2 seconds, indicating
that they are paired and ready to use.
5. If Pairing is not completed within 2 minutes, the units will return to Standby.
20
|
To Next Page
Loading...
Need help?
General
