EasyManua.ls Logo

Carel compactSteam - Maintenance of Other Water Circuit Components; Spare Parts

Carel compactSteam
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
29
ENG
compactsteam” +0300092IE - rel. 1.2 - 14.01.2021
7.3 Maintenance of other water circuit
components
IMPORTANT WARNING:
The external power supply must always be disconnected when
carrying out any maintenance on the humidier.
Do not use detergents or solvents to clean plastic components.
Scale can be removed with a vinegar solution or a mild acetic acid
solution and a soft brush; rinse the cylinder completely with fresh
water.
Cleaning the feed or mixing valve and drain pump
With the power supply disconnected, shut o the water supply and
disconnect the feedwater hose.
Remove the valves and the drain pump by unscrewing the
corresponding screws; check the condition of the valve inlet lters;
Clean with a solution of vinegar or diluted acetic acid using a soft
bristle brush.
Rinse the parts with fresh water.
Replace any components that show signs of excessive wear or that
cannot be completely cleaned. Make sure the gasket is properly tted
in the drain valves.
Cleaning the ll tank: clean the tank from any built-up minerals and
check that water ows freely from the tank to the drain via the drain
pump.
Cleaning the feedwater, ll and overow lines: check that these are
clean and not blocked and replace if necessary.
IMPORTANT WARNING: after replacing or checking the water
circuit, make sure that the components have been correctly reconnected
with the appropriate gaskets. Restart the humidier and complete a
number of cleaning cycles (from 2 to 4, see paragraph 4.4 “Starting with a
new cylinder”), then check that there are no water leaks.
7.4 Spare parts
To replace any faulty components, only use original accessories and spare
parts available from authorised Carel dealers. No changes must be made
without the express authorisation of the manufacturer.
12
12
4
5
1
3
8
6
14
10
11
7
9
12
2
15
Fig. 7.c
Key:
Part number Description
1 CY0S2E0002 cylinder
2 CHM04V0003 Control module 4.5 kg/h
3 CHSW16000 On-o switch for compact steam
4 CHKFAN2000 Fan kit 230V
5 CHKFILT000 Fan lter
6 CHKDIST000 STEAM DISTRIBUTOR KIT
7 CHKFV02003 FILL SOLENOID VALVE + DRAIN TEMPERING 230 V
FOR DRAIN PUMP
8 CHKDP02000 KIT FOR DRAIN PUMP 230V
9 CHKD900000 TUBING TO CONNECT TO DRAIN 90°
10 CHKFT00000 FILL TANK + PLUG FOR DRAIN PUMP
15 CHKDT0000 DRAIN TANK + PLUG FOR DRAIN PUMP
11 CHKTR00001 ROOM TUBING KIT FOR DRAIN PUMP
11 CHKTD00001 DUCT TUBING KIT FOR DRAIN PUMP
12 CHKSCREW00 COVER FASTENING SCREWS
14 CHKBT00001 BOTTOM TANK FOR DRAIN PUMP
- CHKCAB0003 WIRING KIT FOR UNIT WITH DRAIN PUMP
- MCH2004853 RS485 KIT
- CHKADAP000 STEAM CYLINDER HOSE ADAPTER
- 98C425C001 RS232 - RS485 SERIAL CONVERTER

Other manuals for Carel compactSteam

Related product manuals