Carlson Boretrak2 User Manual

BT2 user manual - H-5911-9004-02-B Page | 19
When Carlson Boretrak connects to the probe, the Control tab is populated with Boretrak controls.
If no connection is made, check:
• The Boretrak2 probe is powered ON and flashing red or blue.
• The Boretrak2 is paired to your tablet.
• Bluetooth is switched ON on your tablet.
• No other devices are connected to the same Boretrak2 probe.
Tap Find Boretraks to reattempt a connection.
5.3 Alignment
The survey will start at Hole 1. Position the alignment jig so that it is lined up between Hole 1 and Hole 2 (see Figure
11). Ensure the jig is on solid ground and reasonably close to level (i.e.: within 20 degrees).
Connect the steel cable securely to the Boretrak2 probe using the deployment adaptor (see section 6.6).
Position your probe in the supplied jig. The probe can be rolled around its axis in any rotation, but the nosecone
must point towards Hole 2.
Figure 10 Connecting to a Boretrak2

Carlson Boretrak2 Specifications

General

Brand	Carlson
Model	Boretrak2
Category	Measuring Instruments
Language	English